Keeping on Mending

Some of my regular readers (and I do have regular readers, including 5 followers, Yay!) might remember this sheet from a previous repair post. I've been washing a lot of things on hot to be sure to keep the chicken's mites out of the house, and unfortunately the hot water (my machine does a 90 degree hot wash) has killed the elastic in the fitted sheet. Last time it was on the bed, it just kept coming off at the corners, very annoying.

I thought at first that the elastic had just snapped somewhere, but when I unpicked the seam at one corner, it was obvious it was just destroyed. So I cut the elastic, and pulled the whole lot out. (I could have left it in, but I'm a bit of a perfectionist.)

The fastest way to unpick the seams is to use this handy little tool. It's called a quick unpick, and is invaluable to the sewing enthusiast. No matter how good you get at sewing, there will always be times when you just have to unpick something. Like when you sew the arm of a t-shirt onto the neck opening. (Not that I would do something like that...) And also handy in this case, where you want to undo the stitching to change the elastic. (Handy hint, you can do this for skirts and pants that have become to tight but otherwise still fit, so long as the elastic isn't sewn in.)

Once I'd unpicked that spot, I cut the elastic, and pulled the whole lot out, a very slow and tedious process.

Then I had to replace it with some good elastic. I didn't happen to have a piece long enough, so I pulled out 3 2m bits, and sewed them together with a zig zag stitch like this.

I forgot to take photos of putting the new elastic in unfortunately, but basically you attach a safety pin to the end of the elastic, and use that to thread it through the casing. I found that all the way around a queen sized sheet was a LONG way, so I ended up unpicking the opposite corner too, and threading through from the opposite end as well.

Because of the long length, it's quite hard to get the elastic through evenly, so I simply pulled it as tight as I could, fastened it with the safety pin, and put the sheet on. Each time I'm making the bed, I check it, and often tighten it a little. When it's time to change the sheets again, I'll sew the ends of the elastic together, and close up the opening.

Some people might thing that this is a pointless waste of time, and it's much easier to just go out and buy a new set of sheets. But the reality is that the sheets are still good (and my favourite set), and they have plenty of wear left in them yet. The top sheet and pillow cases are still find, and the fitted sheet is still in reasonable condition. So for about 20 minutes work, I just saved about $100 (I refuse to buy cheap sheets, hate them), and at least half an hour's time had I needed to go buy a new set! Not to mention the damage to the environment to grow the cotton, process it into material, make the sheets, and ship them back and forth. It just makes sense to repair things where you can.